Porter-cable 121 Uživatelský manuál

Oscillating SpindleSanderInstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers in thespaces

10SERVICE AND REPAIRSAll quality tools will eventually require servicing or replacement of parts due towear from normal use. These operations, includi

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

2WARNING: SOME DUST CREATED BY POWER SANDING,SAWING, GRINDING, DRILLING, AND OTHER CONSTRUCTIONACTIVITIES contains chemicals known to cause cancer, bi

32. Dress properly. Do not wear loose clothing or jewelry. Contain longhair. Keep your hair, clothing, and gloves away from moving parts.Loose clothes

4SPECIFIC SAFETY RULES AND SYMBOLS1. Hold tool by insulated gripping surfaces when performing anoperation where the sanding tool may contact hidden wi

n0... no load... alternating or direct current... Class II Construction...

69. AT THE END OF EACH WORK SESSION put the paint chips and debrisin a double plastic bag, close it with tape or twist ties and dispose of properly.10

INSTALLING THE QUICK RELEASE DRUM SYSTEMCAUTION: DISCONNECT TOOL FROM POWER SOURCE. The quick release drum system is easy to assemble and convenient t

8VARIABLE SPEED CONTROLThe Model 121 Oscillating Sander isequipped with a variable speed controldial (B) Fig. 4. The variable speedcontrol can be set

9NOTE: Check guide adjustmentafter changing sanding drums.EDGE GUIDE OPERATIONWhen using the edge guide always startsanding from an edge, so that even